TP5000 Charger Module：How To Use TP5000 Module

The TP5000 module is comprised of the TP5000 integrated circuit as well as an inductor for the built-in switching converter as well as a variety of capacitors and resistors which perform different functions, including decoupling, voltage, and current setting, as well as monitoring voltage.

TP5000 IC:

The TP5000 IC is an integrated single cell LiPo/LiFePo/LiMn charger that has built components that require only an inductor as well as a few passive components to regulate the charging voltage.

LiPo for single cell, LiFePo, or LiMn battery charger

Switch mode converter to increase efficiency

0.1A to 2A programmable charge current

Continuous voltage and constant current, and trickle charging modes

TP4056, TP5100

The TP5000 module is comprised of all the components that are passive required to enable the IC to function as a LiPo charger. The four pins split are called IN+. This represents the pin for input that must not exceed 10V. B+ is connected with the negative terminal on the battery that is being charged. Two GND pins are used as the common ground reference to the module. Two sets of wires are able to be connected between these pins for both the connection to the input as well as the output.

The TP5000 module comes with a header for connecting indicator LEDs to charge and standby LEDs. Certain modules have an unpopulated footprint that can be used to connect another resistor for current sensing that could be connected in parallel to the resistor already in place to alter limits on the power of an IC.

LiPo battery charger

Solar harvesting systems for solar harvesting

Electronics embedded

Appliances powered by batteries